Application of the Force Control on the Working Path Tacking

Authors

Sun-Run Wang, Professor, Department of Mechanical Engineering, National Central University, Chung-Li, Taiwan 32054, R.O.C.
Zhi-Zhong Qiao, Professor, Department of Mechanical Engineering, National Central University, Chung-Li, Taiwan 32054, R.O.C.
Pi-Cheng Tung, Professor, Department of Mechanical Engineering, National Central University, Chung-Li, Taiwan 32054, R.O.C.Follow

Abstract

For the application of tracking the path on workpieces, the CCD (Charge Couple Device) identificating system is generally used as one of the popular resolutions. However, the implementation of CCD identificating system is complex and environmental-limited. This study presents a compliant motion controller by using the end-effector installed with a force sensor. This results the smoothly path tracking on a workpiece. By applying the algorithm of Fuzzy into this compliant motion, the compliant control is improved and the path on the workpiece is found more quickly and accurately. A radius compensating method is used to correct the measured data. The experiments performed have successfully demonstrated the feasibility of the proposed control algorithm.

Recommended Citation

Wang, Sun-Run; Qiao, Zhi-Zhong; and Tung, Pi-Cheng (2002) "Application of the Force Control on the Working Path Tacking," Journal of Marine Science and Technology: Vol. 10: Iss. 2, Article 4.
DOI: 10.51400/2709-6998.2307
Available at: https://jmstt.ntou.edu.tw/journal/vol10/iss2/4