Abstract
the increase of ferrite content. However, the nearly ferritic alloy showed much better passivation behavior, presumably due to the addition of 6% Cr.In aerated solution, no or very small passive region was observed. From the immersion test, the general corrosion was found to be minor. Pitting corrosion was the primary corrosion except for the ferritic alloy. The pits were found more frequently in the ferrite phase or at the interface between the ferrite and austenite phases.
Recommended Citation
Ruscak, M and Perng, T.P
(1993)
"Pitting of Fe-Mn-Al Alloys in NaCl Solution,"
Journal of Marine Science and Technology: Vol. 1:
Iss.
1, Article 1.
DOI: 10.51400/2709-6998.2471
Available at:
https://jmstt.ntou.edu.tw/journal/vol1/iss1/1